|Bullets Manfacturing Process
The manufacturing process used to produce the projectile.
|Best Used For
The Primary or Secondary intended use for the projectile: Hunting, Defense, Target/Competition, Military, Law Enforcement.
The technology used when designing the projectile. For additional information on our technologies, please see our Technology Page.
|Bullet Weight (gr)
The weight of the projectile in grains.
Bullet Length in inches
The primary material used to produce the projectile.
|Ballistic Coefficient (G1)||0.26|
|Notes||This projectile was specifically designed for use in the 300 HAM’R and while it can be used in other cartridges, it may not provide optimum performance. If you wish to use this projectile for the 300 BLK, please note you will not reach optimum velocity due to case capacity constraints imposed by the bullets specifically designed geometry (shorter COAL when seated in a 300 BLK) for the Wilson 300 HAM'R.|
|Minimum Twist Rate||1:15|
|Ogive Length (inches)
The curved portion of the bullet that proceeds the bearing surface. For handloaders this dimension can be used to determine minimum projectile protrusion.
|Bullet Minimum Velocity (fps)
The Minimum Velocity required to obtain Terminal Performance.
|Bullet Maximum Velocity (fps)
Bullet MThe Maximum Velocity that the projectile can withstand without structural or performance failure.aximum Velocity (fps)
|Cost Per Round||$0.55|
|Cartridge||300 Blackout / 300 Whisper®, 308 Winchester, 300 HAM'R®, 302 Whisper, 30-06 Springfield, 300 WSM, 309 JDJ|
|Lead Free Bullet||Yes|
|Manufactured By||Lehigh Defense, LLC|